Filter
Top Products
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofer’s L.P.F. (low-pass
filter) and that of the SMALL speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to OFF and other
speakers are set to LARGE or OFF.
Adjusting the speaker output
levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Touch NEXT on the DSP function menu.
2 Touch SP LEVEL.
3 Touch a or b to select the speaker to
be adjusted.
Each time you touch a or b selects the speak-
er in the following order:
FRONT-L (front speaker left)—CENTER (center
speaker)—FRONT-R (front speaker right)—
REAR-R (rear speaker right)—REAR-L (rear
speaker left)—SUB WOOFER (subwoofer)
# You cannot select speakers whose size is set
at OFF.
4 Touch c or d to adjust the speaker out-
put level.
Each time you touch c or d increases or de-
creases the speaker output level. +10 to –10 is
displayed as the level is increased or de-
creased.
Notes
! You can also display the speaker setting menu
by pressing BOOST button.
! To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at TEST TONE. Both provide the
same results.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Touch NEXT on the DSP function menu.
2 Touch TEST TONE.
3 Touch START to start the test tone out-
put.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
FRONT-L (front speaker left)—CENTER (center
speaker)—FRONT-R (front speaker right)—
REAR-R (rear speaker right)—REAR-L (rear
speaker left)—SUB WOOFER (subwoofer)
Check each speaker output level. If no adjust-
ments are needed, perform step 5 to stop the
test tone.
# The settings do not appear for speakers
whose size is set OFF.
4 Touch c or d to adjust the speaker out-
put level.
Each time you touch c or d increases or de-
creases the speaker output level. +10 to –10 is
displayed as the level is increased or de-
creased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
5 Touch STOP to stop the test tone out-
put.
Notes
! You can also display the speaker output level
menu by pressing BOOST button.
Available accessories
En
64
Section
04