Filter
Top Products
1 Touch NEXT on the initial menu.
2 Touch D. ATT to switch the digital at-
tenuator setting.
Touching D. ATT switches the digital attenua-
tor settings in the following order:
HIGH—LOW
Switching the sound muting/
attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
1 Touch NEXT on the initial menu.
2 Touch TEL to select any of the muting,
attenuation, mixing or off.
Touch TEL until the desired setting appears in
the display.
! MUTE – Muting
! ATT 20 – Attenuation (ATT 20 has a stron-
ger effect than ATT 10)
! ATT 10 – Attenuation
! OFF – Turn the sound muting/attenuation
off
Notes
! The sound is muted or attenuated, MUTE or
ATT are displayed and no audio adjustment is
possible.
! Operation returns to normal when the phone
connection or the voice guidance is ended.
Resetting the audio functions
You can reset all audio functions except vo-
lume.
! Only when the multi-channel processor
(e.g., DEQ-P8000) is connected to this unit,
you can operate this function.
1 Touch NEXT on the initial menu.
2 Touch RESET.
3 Touch RESET.
4 Touch RESET again to reset audio func-
tions.
# To cancel resetting the audio functions, touch
CANCEL.
Setting the illumination switch
You can choose whether to have the illumina-
tion of this unit switch on/off when the ignition
key is turned to the ACC position or the power-
off position.
% Touch ILM SW on the initial menu to
turn the illumination switch on.
Set the illumination switch ON to have the illu-
mination of this unit remain on when the igni-
tion key is turned to the ACC position. Set to
OFF to have the illumination off when the igni-
tion key is turned to the ACC position.
# To turn the illumination switch off, touch
ILM SW again.
Note
Never set the illumination switch on if the vehicle
does not have the ACC position. It may cause bat-
tery leakage.
Operating this unit
En
40
Section
03