Filter
Top Products
WARNING
Do not open the set as there is a risk of electric shock! Under no circumstances should you try
to repair the set yourself, as this will invalidate the warranty
If a fault occurs,first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints,consult your dealer or service
center.
Problem Solution
No sound /power – Volume not adjusted.Adjust the VOLUME.
– Headphones connected. Disconnect headphones.
– AC mains not securely plugged to wall outlet. Plug in properly.
No reaction to controls – Electrostatic discharge.
Disconnect the unit from the AC power supply reconnect after
a few seconds.
TIMER/SLEEPER – Clock time not set. Set the correct clock time.
does not work
Severe radio hum or noise – Electrical interference set too close to TV,VCR or computer.
Increase the distance.
Poor radio reception – Weak radio signal.
FM: Direct the FM antennawire for optimum reception.
NO DISC or – CD badly scratched or dirty.Replace/ clean CD,see Maintenance.
DISC NOTREADABLE
– CD-R(W) is blank or the disc is not finalised.Use a finalised CD-R(W)
.
indication – Laser lens steamed up.Wait until lens has cleared.
The CD skips tracks – CD damaged or dirty. Replace or clean CD.
– SHUFFLE or PROGRAM is active. Switch off SHUFFLE/ PROGRAM.
Remote control does – Batteries exhausted. Insert fresh batteries
not function properly – Batteries incorrectly inserted. Insert the batteries correctly.
– Distance/ angle between the set too large.
Reduce the distance/ angle.
Troubleshooting
17
English
XP MZ5/37 15-03-2002 11:23 Pagina 17