Filter
Top Products
22
English
Tuning to radio stations
1 Press POWER to switch on the last selected source.
2 Adjust SOURCE (or press TUNER on the remote
control) to select the desired band : FM or AM.
➜ If an FM station is received in stereo, “STEREO” icon
appears.
3 If necessary, press TUNING•PRESET to switch on tuning
mode.
4 Press and hold S or T until the frequency indication
starts to change, then release.
➜ The system automatically tunes to the next strong radio
station.
● To tune to a weak station, press S or T briefly and
repeatedly until optimal reception is found.
5 Repeat step 4 if necessary until you find the desired radio
station.
Presetting radio stations
You can preset up to 30 AM and 30 FM stations regardless
of the reception. Tune in the desired stations using
automatic or manual tuning.
Manual Preset
1 Tune to your desired radio station (refer to “Tuning to radio
stations”).
2 Press PROGRAM.
➜ “PROG” icon starts flashing.
➜ The next available preset number is displayed for
selection.
To store the radio station to another preset
number
● While “PROG” icon is flashing, press S or T ( 1 / 2
on the remote control) to select the desired preset
number.
Note:
– If “PROG” icon goes off before you select the desired
preset number, press PROGRAM again.
3 Press PROGRAM again to store the radio station.
➜ “PROG” icon stops flashing.
● Repeat steps 1–3 to store other radio stations.
Automatic Preset
1 Adjust SOURCE (or TUNER on the remote control)
again to select the desired band : FM or AM.
To begin automatic preset from a desired preset
number
● Press TUNING•PRESET to switch on preset mode and
followed by S or T ( 1 / 2 on the remote control)
to select the desired preset number.
2 Hold down PROGRAM until the “PRESET” icon flashes.
➜ All available radio stations with sufficient signal strength
will be stored automatically.
➜ It will stop automatically when all the available radio
stations are stored or the memory for 30 presets is used.
● To store stations on the other band, repeat steps 1-2.
To stop storing the automatic preset
● Press PROGRAM again.
Notes:
– If no preset number is selected, automatic preset will begin
from preset (1) and all your former presets will be overridden.
– During programming, if no key is pressed within five
seconds, the system will exit the program mode automatically.
Listening to preset radio
stations
● In tuner mode, press TUNING•PRESET to switch on
preset mode and followed by S or T ( 1 / 2 or
numeric keypad 0-9 on the remote control) to select
the desired preset number.
➜ The preset number, radio frequency, and waveband are
displayed.
Radio Reception
RADIO RECEPTION