Filter
Top Products
3139 115 20032
41
English
MAINTENANCE TROUBLESHOOTING
Maintenance
Cleaning the Cabinet
• Use a soft cloth slightly moistened with
a mild detergent solution. Do not use a
solution containing alcohol, spirits,
ammonia or abrasives.
Cleaning Discs
• When a disc becomes
dirty, clean it with a
cleaning cloth. Wipe
the disc from the
centre out.
• Do not use solvents
such as benzine,
thinner, commercially available cleaners,
or antistatic spray intended for analogue
records.
Cleaning the disc lens
• After prolonged use, dirt or dust may
accumulate at the disc lens. To ensure
good playback quality, clean the disc
lens with Philips CD Lens Cleaner or any
commercially available cleaner. Follow
the instructions supplied with cleaner.
Warning! Under no circumstances
should you try to repair the set
yourself as this will invalidate the
guarantee. Do not open the set as
there is a risk of electric shock.
• If a fault occurs, check the points listed
below before taking the system for
repair.
• Should any problems persist after you
have made these checks, consult your
nearest dealer or service centre.
DVD-VIDEO Player Operation
Distorted picture or no colour with
player menu.
• The disc format does not match your
TV's video signal (PAL/NTSC).
™
Replace a recommended disc (refer to
the instruction of this manual).
• The system setting is not correct.
™
Make sure the NTSC/PAL setting at the
player matches the video signal of your
television (see NTSC/PAL setting).
• Check the disc for fingerprints.
™
Clean with a soft cloth, wiping from
centre to edge.
™
Sometimes a small amount of picture
distortion may appear. This is not
malfunction.
No return to start-up screen when disc
is removed.
• Check to see if the programme requires
another disc to be loaded.
™
Reload a disc.
™
Reset by switching the player off, then
on again.
Player does not respond to all
operating commands during playback.
• Operations are not permitted by the
disc.
™
Refer to the instruction of the disc.
No audio at digital output.
• The digital connections are not properly
connected or connected wrongly
™
Check the digital connections.
• Incorrect digital output settings.
™
Check the settings menu to make sure
the digital output is set to ALL or PCM.
™
Check if the audio format of the
selected audio language matches the
receiver capabilities.
No picture on TV screen.
• The video cable is not connected.
™
Connect the cable between the system
and TV.
1pg 01-42/D5/22-Eng new 9/14/00, 8:37 AM41