Filter
Top Products
Hookups - TV (cont’d,) 13
Connecting to a TV with an S-Video In jack
FR
FL C SR SL
SPEAKERS (8‰)
CENTER
LINE OUT
AUDIO
OUT
AUDIO
IN
VIDEO
OUT
WOOFER
LINE OUT
TV AUX
S- VIDEO
OUT
Pr/Cr
Pb/Cb
Y
COMPONENT
VIDEO OUT
COAXIAL
OPTICAL
DIGITAL
OUT
AM
FM
(75‰)
AM/FM
ANTENA
L
R
1
Connect the DVD Receiver’s S-VIDEO OUT jack to the
S-VIDEO IN jack on your TV. You will need an S-Video cable
(not supplied).
2
To hear TV channels through the DVD Home Cinema System,
connect the supplied red and white audio cables to the
DVD Receiver’s red/white, right/left AUDIO IN jacks and to
the TV’S right/left AUDIO OUT jacks. Match the cable colors
to the jack colors.
3
Connect the power cords of the DVD Receiver and TV to a
power outlet.
4
Turn on the TV and set it to the correct S-Video In chan-
nel. Go to the lowest TV channel and change channels down until
you find the S-Video In channel. (It is not channel 3 or 4 as it might
be when using a VCR.) See your TV owner’s manual for details.
5
Press STANDBY-ON
yy
on the front of the DVD Receiver to
turn on the DVD Receiver. The red Standby light will disappear.
6
It is not necessary to set VIDEO OUT to S-VIDEO.
S-VIDEO is the DVD Receiver’s default setting. However, if your
picture is distorted, check the VIDEO OUT setting. Make sure it is
set to S-VIDEO. Details are on page 22.
1
2
3
•You only need one video connec-
tion between the TV and the
DVD Receiver. You cannot use S-
Video and Component Video at
the same time.
• If you used the yellow VIDEO
OUT jack on the DVD Receiver
to connect it to the TV, you do
not need to adjust the VIDEO
OUT setting.
Helpful Hints
mrd250book 2/14/03 10:49 AM Page 13