Filter
Top Products
23
English
MC-V320/21-1
General information on
recording
● Recording is permissible insofar as copyright or
other rights of third parties are not infringed.
● For recording, use only NORMAL (IEC type I)
tapes on which the tabs have not yet been
broken. This deck is not suited for recording on
METAL (IEC IV) type tapes.
● The best recording level is set automatically.
Altering the VOLUME, DBB or INTERACTIVE
SOUND controls will not affect the recording in
progress.
● At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
● To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.
Synchro start CD recording
1 Select CD source.
2 Insert a disc and if desired, program track
numbers.
3 Press to open the tape door.
4 Insert a suitable tape into the deck and close the
tape door.
5 Press REC to start recording.
➜ REC is shown during recording.
➜ Playing of the CD program starts
automatically from the beginning of the CD
after 7 seconds. It is not necessary to start the
CD player separately.
6 To stop recording, press STOP 9.
Recording from the radio
1 Select TUNER source and tune to the desired
radio station (see “Tuning to radio stations”).
2 Press to open the tape door.
3 Insert a suitable tape into the deck and close the
tape door.
4 Press REC to start recording.
➜ REC is shown during recording.
5 To stop recording, press STOP 9.
Recording from Aux
1 Select AUX source.
2 If necessary, prepare the additional appliance for
recording.
3 Press REC to start recording.
➜ REC is shown during recording.
4 To stop recording, press STOP 9.
Recording timer
To record from the radio, you will need to use a
preset radio station and to set a start (ON) and
finish (OFF) time.
1 Insert a suitable tape into the deck.
➜ If desired, press PROG/ REV to select tape
reverse mode option.
PLAY 1 SIDE : for recording one side only
PLAY A AND B : for recording on both sides
REPEAT A AND B : for recording on both sides
2 Select TUNER SOURCE and the preset radio
station to record from.
3 Press STANDBY ON to switch the system to
standby mode. Press TIMER SET / for more
than 2 seconds.
➜ flashes and a source is displayed.
4 Press SOURCE repeatedly, until REC TUN
source is displayed.
5 Press TIMER SET / to confirm the source.
➜ SET ON TIME is displayed, and the clock
digits for the hours flash.
6 Press VOLUME –/+ to set the hours.
7 Press TIMER SET / again.
➜ The clock digits for the minutes flash.
8 Press VOLUME –/+ to set the minutes.
9 Press TIMER SET / to confirm the ON start
time.
➜ SET OFF TIME is displayed, and the
clock digits for the hours flash.
10 Repeat steps 6-8 to set the finish time.
11 Press TIMER SET / to confirm the timer
settings.
➜ is shown and the recording timer is now
set.
Tape Operation/Recording