Filter
Top Products
15
English
MC-V320/21-1
CD/VCD/MP3-CD Operation
Playing a disc
● CD-ROM, CD-I, CDV, DVD or computer CDs,
however, are not possible.
1 Select VCD/ CD source.
2 Press CD OPEN on the top
of the system to open the CD compartment.
➜ OPEN is displayed when you
open the CD compartment.
3 Put a disc with the printed side facing up and
press down. Push the front panel to close.
➜ READING as the CD player scans the
contents of a disc, and then the total number of
tracks and playing time are shown. (CD/ VCD
only)
4 Press to start playback.
➜ Current track number and elapsed playing
time of the track are displayed during disc
playback.
5 To interrupt playback press . Press again
to resume play.
6 To stop disc playback, press STOP 9.
Note: CD play will also stop when;
– the CD door is opened.
– the disc has reached the end.
– you select another source: TAPE, TUNER or AUX.
For MP3-CD only
● Load a MP-3 CD format music disc on the disc
tray.
➜ The total album number and total title/ track
number "018 120" will be displayed. MP3,
ALB and TRH will be shown.
Notes:
– Load the discs with the label side facing up.
– To ensure good system performance, wait until
the disc completely reads the disc before
proceeding.
– For MP3-CD, the disc reading time may exceed
10 seconds due to the large number of songs and
different formats compiled into one disc.
Selecting a different track
● Press or once or repeatedly until the
desired track number appears in the display.
● If you have selected a track number shortly after
loading a disc or in the PAUSE position, you will
need to press to start playback.
● Press digit 0/-- – 9 on the remote control to
direction selecting the desired track.
For MP3-CD only
To select a desired Album
● Press or (or ALBUM –/+ on Remote
Control) repeatedly until the desired Album
appears on the display.
➜ ALB and “0XX 120” will be displayed.
To select a desired Title/ Track
● Press or (on TITLE –/+ on Remote
Control) repeatedly until the desired Title
appears on the display.
● Use the digital keys on the remote control to
select the track.
➜ TRH and “018 XXX” will be displayed.
Notes:
– ALB represents ALBUM and TRH represents
Title/ Track, "XX" or "XXX" is the current selected
Album or Title/ Track number.
– Press & hold digit “0/ –” will show
– “– –” for CD & VCD
– “– – –” for MP3 then Press 0-9
Finding a passage within a track
To search for a particular passage during
playback:
1 Press and hold down on or (on à / á
on Remote Control)
➜ The disc is played at high speed and low
volume. (CD only)
2 When you recognise the passage you want,
release or . (on à / á on Remote
Control)
➜ Normal playback continues.
Note:
– During a disc programme or if SHUFFLE/
REPEAT active, searching is only possible within the
same track.