Filter
Top Products
22
English
MC-V320/21-1
Tape Operation/Recording
Tape playback
1 Select TAPE source.
2 Press to open the tape door on the top of the
system.
3 Insert a recorded tape and close the tape door.
● Load the tape with the open side downward and
the full spool to the right.
➜ The display shows TAPE briefly. The tape
counter 0000 display with the SIDE A or SIDE B.
4 Press to start playback.
5 By pressing or , fast winding of tape is
possible in both directions.
● During fast winding, you can monitor the tape
message with the tape counter.
6 To stop the tape, press STOP 9 .
● To reset the tape counter, press STOP 9 again.
Note:
– The sound source cannot be changed while
recording a tape.
– “NO TAPE” will be shown if no tape inserted.
Switching tape sides
The tape side can be switched manually or
automatically before or during tape playback.
● Press DISPLAY BAND on set only.
➜ The display shows SIDE A or SIDE B.
Reverse mode options
● Press PROG/ REV repeatedly to select your
option;
PLAY 1 SIDE : playback or record stops at
the end of the tape.
PLAY A AND B : both sides are or recorded
played once.
REPEAT A AND B : both sides are played
repeatedly, up to 5 times
each side.