Philips MC-V320 Stereo System User Manual


 
19
English
MC-V320/21-1
Resume
This feature is also applicable to audio CD
(except for MP3-CD).
In stop mode, press RESUME on the remote
control to start playback again from where you
have stopped.
Note:
Resume information is lost if opened the disc
tray, change source or disconnected the system
from the power supply.
Resume is not available when PBC mode is
switched on.
Slow
1 Press SLOW on the remote control to watch a
VCD at a slower speed. There are 3 types of
slow modes to select.
The sound will be muted.
On TV screen, “SLOW 1”, “SLOW 2” or
SLOW 3” will be displayed.
2 To resume playback at normal speed, press
PLAYÉÅ.
Vocal
This feature allows you to fade out the original
vocal from a karaoke VCD. This feature is used
together with Echo mode. You can also use it to
select the different audio modes.
Pressing VOCAL on the remote control
repeatedly allows you to select the following
modes.
STEREO STEREO VOCAL LEFT
STEREO VOCAL RIGHT MONO LEFT
MONO RIGHT STEREO
STEREO – same effect as the original recorded
disc.
STEREO VOCAL LEFT/RIGHT – fade out the
original vocal for special recorded Karaoke disc
only (with the ECHO mode switched on).
MONO LEFT/RIGHT – select the language on a
bilingual VCD.
Ensure that Echo mode is switched on
when press VOCAL to fade out the original
vocal during STEREO VOCAL LEFT/RIGHT
mode.
CD/VCD/MP3-CD Operation
Key Control ( I È i )
This feature allows you to change the key tone
of your vocal range.
Press
II
II
I on the remote control to decrease
vocal key level.
"KEY -X" appears on the display.
Press
ii
ii
i on the remote control to increase vocal
key level.
"KEY +X" appears on the display.
Press
ÈÈ
ÈÈ
È on the remote control to restore vocal
key to original setting.
"KEY FLAT" appears on the display.
Note:
–“X” denotes the key level.
Echo
This feature allows you to add echo while singing
or talking through a microphone.
Press ECHO
--
--
-/
++
++
+ on the remote control to
decrease, increase or switch off the echo effect.
"MIC OFF, MIC ON, ECHO +X" appears on
the display.
Notes:
–“X” denotes the echo level.
You are advised to switch off the echo effect
when not using the feature.
Microphone Mixing
Connect a microphone (not supplied) to the
system allowing you to sing along with the music
source.
1 Connect a microphone to the MIC jack.
Before connecting the microphone, set the
LEVEL to the minimum level to prevent
howling sound.
2 Press VCD/ CD source to be mixed and start
playback.
3 Press Echo to switch “MIC ON“.
4 Adjust the volume level of the source with
VOLUME –/+ control.
5 Adjust the microphone volume with LEVEL
control.
Notes:
Keep the microphone away from the speakers to
prevent howling.
Mixing only on VCD/ CD/ MP3 mode.
For Recording, please refer to “Tape
Operation/ Recording”.