Filter
Top Products
18 EN
8 Other features
Set the alarm timer
This unit can be used as an alarm clock. You can
select DISC, FM, or USB as the alarm source.
Note
•
Make sure that you have set the clock correctly.
1 In standby mode, press and hold TIMER/
SLEEP for more than two seconds.
» "TIMER SET" (timer set) scrolls on the
display panel. Then, "SELECT SOURCE"
is displayed.
2 Select a source (disc, USB, or tuner).
» The hour digits are displayed and begin
to blink.
3 Press / (or VOL -/VOL +) repeatedly
to set the hour, and then press TIMER/
SLEEP.
» The minute digits are displayed and
begin to blink.
4 Repeat step 3 to set the minute, and adjust
volume.
Note
•
If no button is pressed in 90 seconds, the unit exits
timer setting mode automatically.
To activate or deactivate the alarm timer:
• In standby mode, press TIMER/SLEEP
repeatedly to activate or deactivate the
alarm.
» If the timer is activated,
is displayed.
Tip
•
If the disc/USB source is selected, but no disc is placed
or no USB connected, the unit switches to the tuner
source automatically.
Set the sleep timer
• To set the sleep timer, when the unit
is switched on, press TIMER/SLEEP
repeatedly to select a set period of time
(in minutes).
» When the sleep timer is activated,
is displayed.
To deactivate sleep timer:
• When the unit is switched on, press
TIMER/SLEEP repeatedly until [SLP OFF]
(sleep off) is displayed.
» When the sleep timer is deactivated,
disappears.
Listen to an external device
You can listen to an external device through this
unit with an 3.5mm audio cable (not supplied).
1 Make sure that the external audio device
is connected to this unit (see 'Connect an
external audio device' on page 10).
2 Press AUX to select the AUX IN source.
3 Start to play the external device (see the
user manual of the external device).