Filter
Top Products
11
English
EN
4 Get started
Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshineorre.Neverdiscardbatteriesinre.
• Risk of decreased battery life! Never mix different
brands or types of batteries.
• Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery:
1 Open the battery compartment.
2 Insert the supplied AAA batteries with
correct polarity (+/-) as indicated.
3 Close the battery compartment.
a
b
c
Set clock
1 In standby mode, press and hold PROG/
CLOCK SET on the remote control for
more than two seconds.
» [24H] or [12H] hour format is
displayed.
2 Press / (or VOL -/VOL +) to select
[24H] or [12H] hour format, and then
press PROG/CLOCK SET.
» The hour digits are displayed and begin
to blink.
3 Press / (or VOL -/VOL +) to set hour,
and then press PROG/CLOCK SET.
» The minute digits are displayed and
begin to blink.
4 Repeat step 3 to set minute.
Note
•
If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Tip
•
In Eco power mode, you can press PROG/CLOCK
SET to view the clock information.
Activate demonstration mode
In this mode, you can see an overview of all
features.
• In standby mode, press and hold
on the
main unit to activate demonstration mode.
» A demonstration of major available
features starts.
To deactivate the demonstration mode:
• Press
on the main unit again.