Filter
Top Products
3139 116 19774
41
English
MAINTENANCE TROUBLESHOOTING
Maintenance
Cleaning the Cabinet
• Use a soft cloth slightly moistened
with a mild detergent solution. Do
not use a solution containing alcohol,
spirits, ammonia or abrasives.
Cleaning Discs
• When a disc
becomes dirty, clean
it with a cleaning
cloth. Wipe the disc
from the center out.
• Do not use solvents
such as benzine,
thinner, commercially available
cleaners, or antistatic spray intended
for analog records.
Cleaning the disc lens
• After prolonged use, dirt or dust may
accumulate at the disc lens. To ensure
good playback quality, clean the disc
lens with Philips CD Lens Cleaner or
any commercially available cleaner.
Follow the instructions supplied with
cleaner.
Warning! Under no
circumstances should you try to
repair the set yourself as this will
invalidate the guarantee. Do not
open the set as there is a risk of
electric shock.
• If a fault occurs, check the points
listed below before taking the system
for repair.
• Should any problems persist after
you have made these checks, consult
your nearest dealer or service center.
DVD-VIDEO Player
Operation
Distorted picture or no color
with player menu.
• The disc format does not match
your TV's video signal (PAL/NTSC).
™ Replace a recommended disc (refer to
the instruction of this manual).
• The system setting is not correct.
™ Make sure the NTSC/PAL setting at
the player matches the video signal of
your television (see NTSC/PAL setting).
• Check the disc for fingerprints.
™ Clean with a soft cloth, wiping from
center to edge.
™ Sometimes a small amount of picture
distortion may appear. This is not
malfunction.
No return to start-up screen
when disc is removed.
• Check to see if the program
requires another disc to be loaded.
™ Reload a disc.
™ Reset by switching the player off, then
on again.
Player does not respond to all
operating commands during
playback.
• Operations are not permitted by the
disc.
™ Refer to the instruction of the disc.
No audio at digital output.
• The digital connections are not
properly connected or connected
wrongly
™ Check the digital connections.
• Incorrect digital output settings.
™ Check the settings menu to make sure
the digital output is set to ALL or PCM.
™ Check if the audio format of the
selected audio language matches the
receiver capabilities.
No picture on TV screen.
• The video cable is not connected.
™ Connect the cable between the system
and TV.
pg 01-43/D5/37-Eng 7/13/00, 11:52 AM41