Filter
Top Products
10 Pelco Manual C1014M-B (10/97)
4.0 INSTALLATION FOR ATM MACHINES
This section covers the installation of the ICIMI1000 interface cable with the Diebold,
IBM, and NCR ATM machines.
4.1 INTER-CHECK
®
PREPARATION
1. Check to see if Pelco supports the communication protocol your ATM is run-
ning. ATMs having a different protocol may emulate one of the supported pro-
tocols listed.
The ATM protocols that Pelco supports are:
Diebold 910/911 : IBM 2260
Diebold 910/911 : IBM 2265
Diebold 910/911 : IBM 3275
Diebold 910/911 : IBM 3624
IBM Native Mode
Diebold 910/911 : NCR751/279
NCR Native Mode
Diebold 910/911 : SNA/SDLC
Diebold 910/911 : TC 500/700
Diebold 910/911 : TC 500/700 Sync
2. Check the appropriate hardware connection needed to connect into the ATM’s
modem. Usually the connection will use the ICIMI1000 interface cable with 25-pin
connector. Contact the factory If the ATM uses a 9-pin or other connector.
3. Find out the communication parameters (such as baud rate and parity) needed
by the ATM’s modem. This information is available from the bank support group
or ATM network for your particular ATM machine.
Proceed to Section 4.2, CONNECTING THE INTERFACE.
4.2 CONNECTING THE INTERFACE
The Inter-Check
®
interface cable connection between the ATM machine and the
modem is a fairly easy external connection (see Figure 3). Refer to Figure 1 for the
wiring diagram for one ATM machine and Figure 2 for the wiring diagram for two
ATM machines.
Perform the following procedures to interface the ATM machine and the Inter-Check
®
:
1. Disconnect the ATM data cable that plugs into the modem port.
2. Connect the ICIMI1000 to the ATM network modem
3. Connect the ATM data cable into the open end of the ICIMI1000.
4. Connect the RJ14 plug on the ICIMI1000 interface cable to the DATA IN con-
nection on the Inter-Check
®
unit.
5. Set the SW1 switch on the ICIMI1000 interface cable toward the male plug (in
the direction of the gray phone cable.)
Proceed to Section 4.3, INTER-CHECK
®
PROGRAMMING
CAUTION:
Installation
should be in accordance
with all applicable local
and national electric
codes, utilizing approved
materials only.