Filter
Top Products
8 Pelco Manual C1014M-B (10/97)
5. Verifone uses the Epson Model TM930II as the standard printer on this regis-
ter. If you are using the Epson Model TM950II printer, with 9-pin “D” style
connector, you will need to use the Pelco ICIDRP interface cable.
6. Set the SW1 switch on the ICIMI1000 interface cable toward the male plug.
Proceed to Section 3.3, INTER-CHECK
®
WIRING KITS.
3.3 INTER-CHECK
®
WIRING KITS
Refer to the wiring configurations shown in Figure 1 and 2 if you are installing
the Inter-Check
®
unit more than four feet away from the printer. A maximum of
1,500 feet (457.2 m) of 18 AWG shielded wire is recommended (not provided).
One (1) ICI1000WK wiring kit is provided with the ICI1000SE and ICI1000SI Inter-
Check
®
unit. This kit includes the following components:
2 RJ14 phone jacks
1 Straight-through 6 conductor phone cable
One (1) ICI2000WK wiring kit is provided with the ICI2000D Inter-Check
®
unit. This
kit includes the following components:
3 RJ14 phone jacks
1 Straight-through 6 conductor phone cable