Filter
Top Products
16 C2649M (9/07)
MOUNTING THE TRANSMITTER/RECEIVER
The FT106011 transmitter/FR106011 receiver can be mounted into a rack or can be used as a stand-
alone module. As a stand-alone module, the unit can be placed on a desktop or can be mounted to
a wall.
MOUNTING THE TRANSMITTER/RECEIVER INTO A RACK
The FT106011 transmitter/FR106011 receiver can be installed into an RK5000 Series rack mount
chassis, which can be mounted into an industry-standard 19-inch (48.26 cm) equipment rack. The
RK5000 Series rack mount chassis includes the following models:
• RK5000PS-3U and RK5000-3U: Designed to accommodate fiber optic modules as follows:
– The RK5000PS-3U rack mount chassis provides 12 module slots and a power supply.
– The RK5000-3U rack mount chassis provides 14 module slots (a power supply is not
included). Power to the modules can be supplied using the optional external power
supply (EPS5000-120).
For additional information, refer to the RK5000PS-3U/RK5000-3U Fiber Rack Mount Chassis
Installation manual.
• RK5000PS-5U: Designed to accommodate Endura
™
modules but can also accommodate fiber
optic modules with the use of the RK5001-1UEXP adapter kit. The RK5001-1UEXP adapter kit
is required for installation of the FT106011 transmitter/FR106011 receiver into the
RK5000PS-5U chassis.
For information about the RK5000PS-5U chassis, refer to the RK5000PS-5U Rack Mount Chassis
Installation manual.
MOUNTING THE TRANSMITTER/RECEIVER TO A WALL
The FT106011 transmitter/FR106011 receiver can be mounted to a wall in the following ways:
• Using the supplied wall clip for attachment of a single module to a wall. For installation
instructions, refer to the Mounting the Transmitter/Receiver Using the Wall Clip section.
• Using the optional WM5001 wall mount kits, which are designed for mounting of single-width
fiber optic modules. The WM5001-3U base kit allows mounting of a single module to the wall.
The WM5001-3UEXP expansion kit allows mounting of an additional module. It is
recommended that a maximum of three expansion kits be used with the base kit, allowing a
maximum of four single-width modules to be mounted to the wall.
NOTE: The WM5001 wall mount kits can be used with the WM5002 wall mount kits, which are
designed for mounting of double-width fiber optic modules. If mounting a mix of single-width
and double-width modules is desired, it is recommended that a maximum of two single-width
modules and one double-width module be mounted in combination with one another.
For mounting instructions using the wall mount kits, refer to the WM5000 Series Wall Mount
Kit Installation manual.