Filter
Top Products
12 C2649M (9/07)
Installation
PACKAGE CONTENTS
The following items are supplied:
1 FT106011 transmitter or FR106011 receiver
1 Regulated switching power supply with four plug adapters (North American, Australian, U.K.,
and European configurations); 100-240 VAC, 50-60 Hz input, 12 VDC output
1 1 small flat-tip screwdriver
1 Wall clip with two 4-40 x 0.25-inch Phillips pan head screws with lock washers (for attachment
of single module to wall)
1 FT106011/FR106011 Fiber Transmitter and Receiver Installation manual (this manual)
SETTING THE AUDIO SIGNAL AND IMPEDANCE MODE
An Audio Select switch, which is a 10-position rotary switch, is provided on the bottom of the
FT106011 transmitter and the FR106011 receiver (refer to Figure 5). The Audio Select switch allows
you to set the desired audio mode of operation.
With the FT106011 transmitter/FR106011 receiver powered off, set the Audio Select switch to the
desired mode of operation using the supplied screwdriver. Table B lists Audio Select switch settings
and associated audio modes of operation as indicated on the bottom of the units.
NOTE: If you wish to change the audio mode after the FT106011 transmitter/FR106011 receiver has
been powered on, power off the transmitter/receiver, change the audio mode, and then power on the
transmitter/receiver again.