Filter
Top Products
46
The following describes the list of event labels in the DC TRIGGER setup menu and which
event activates the Main (1) or Zone (2) Triggers.
Event Label Event Executed to Activate Trigger
Power DC Trigger is activated by turning on the system from that zone.
Manual DC Trigger is manually activated by pressing the Shift + Volume
̅ ̅
̅ ̅
̅ or
̃ ̃
̃ ̃
̃ buttons.
Dimmer DC Trigger is on as long as the front panel dimmer is off.
Status DC Trigger is on when the status display is activated or setup menus
are on.
Source: DC Trigger is activated when TRIGGER SOURCE = YES has been set in
the SOURCE SETUP menu, (see above) and the source has been selected.
Component video: DC Trigger activates when a Source with an assigned Component
Video is selected.
Digital input: DC Trigger activates when there is no signal present at any of the
Digital inputs.
Triggering Examples
Power: Turning on a power amplifier when the AVC-2500 is powered on.
Manual: Manually activating a component or accessory.
Dimmer: Dimming room lights at the same time the front panel dimmer is
activated.
Status: Turning on an “operator light” near the equipment when the Status
display is activated.
Source: Controlling various Source-dependent devices, lights, curtains,
screens, etc.
Component video: Controlling various Component Video output-dependent devices,
screens, projectors, etc.
Digital input: Controlling various digital components, for example to turn lights on
when a DVD stops playing.
Setup Menu Level Seven – System Setup Procedures
These procedures are for setting miscellaneous system settings including setting the sleep
timer’s attenuation rate, and restoring all factory default settings.
1. Press and hold the Setup/Trim button on the remote control until SOURCE SETUP appears
on the front panel or on-screen display.
2. Press Setup/Trim until SYSTEM SETUP and SLEEP RAMPING: FAST appear in the displays.
3. Press the Volume
̅ ̅
̅ ̅
̅ or
̃̃
̃̃
̃ buttons to select SLOW if you want the audio to fade slowly
during the last three minutes of the sleep timer.
4. Press the Tune
୵ ୵
୵ ୵
୵ or
୴୴
୴୴
୴ buttons until and TUNER REGION: US/CANADA or EUROPE appears
in the displays.
5. Press the Volume
̅ ̅
̅ ̅
̅ or
̃ ̃
̃ ̃
̃ buttons to select US/CANADA or EUROPE.
6. Press the Tune
୵ ୵
୵ ୵
୵ or
୴୴
୴୴
୴ buttons until and FACTORY RESET appears in the displays.
7. Press the Mem/Enter button to restore factory default settings.
Warning! Pressing the
Mem/Enter
button immediately erases all of your previously programmed
settings.
8. The AVC-2500 turns off after resetting factory defaults.
9. Press the Setup/Trim button to return to normal operation.