Filter
Top Products
LCD. If it is abnormally, it changes to “00NG ”.
5. Press the PLAY key (“00OK ” or “00NG ” changes to “T3E** ”,
playback-only disc adjustment is finished.).
Note:
When “00NG” is displayed, check “7. Troubleshooting Guide” in order.
6.2.6. How to get out the adjustment mode
Remove the battery when you finish the adjustment mode.
6.3. Checking the main unit's keys
1. Set the battery and connect the remote controller.
2. Turn off the power. Then, with the main unit’s HOLD switch at ON,
press the buttons of the remote controller in order from 4 to 1. (as
shown in Fig. 5 )
3. When entering the main unit’s key check mode, “E KEX ” will be
displayed on the LCD of main unit and remote controller. (If it is
not displayed, perform the procedures written above again.)
4. Confirm the display of LCD by pressing any keys on the main unit.
There is no order to press the keys.
Mian unit’s keys Letters on LCD
PLAY A
STOP B
FOW C
REV D
HOLD OFF E
REC F
VOL+ G
VOL- H
MARK MODE I
MODE J
EQ K
5. Remote controller’s LCD lights “E*** ” and main unit’s LCD lights
all when you can detect all keys.
6. Perform below voltage check about the keys come under if you
cannot detect the key.