Filter
Top Products
OTHER OPERATIONS
ENGLISH
30
RQT8043
RQTX0029
Adjusting the volume of each speaker:
Speaker level adjustments
This is one of the ways to get appropriate
surround effects.
Preparation
1 While stopped and no on-screen display is shown
To output a test signal.
L: Front left C: Center
R: Front right RS: Right surround
LS: Left surround
•
There is no output from SW (subwoofer)
channel.
2 To set the volume level normally used for
listening.
3 To adjust the speaker level for each speaker.
OR
• Adjust the speaker levels to the same level
as the front speakers.
C, RS, LS: −6 dB to +6 dB
To stop the test signal
Press [TEST] again.
To adjust speaker level during play
(Effective when playing multi-channel audio or
when Dolby Pro Logic II is on.)
1. Press and hold [–CH SELECT] to select the
speaker.
L C R RS LS SW
SW: Subwoofer
• You can adjust SW only if the disc includes a
subwoofer channel.
• “SW” does not appear on the display and is
not adjustable when “ŸPL II” is lit.
• “S” appears on the display when “MOVIE”,
“MUSIC” is selected with Super Surround
(\ page 29).
In this case, you can adjust both surround
speaker levels at the same time using [5, ∞].
S: −6 dB to +6 dB
2. Press [5] (increase) or [∞] (decrease) to
adjust the speaker level for each speaker.
C, RS, LS, SW: −6 dB to +6 dB
(L, R: Only the balance is adjustable.)
• To adjust the balance of the front speakers,
while “L” or “R” is selected, press [2, 3].
Using sound effects (continued)
RQTX0029-B10.indd 30RQTX0029-B10.indd 30 1/21/07 4:45:54 PM1/21/07 4:45:54 PM