Filter
Top Products
RQT8606
10
Simple Setup
[Note]
The included AC mains lead is for use with this unit only. Do not use it with other equipment. Also, do not use cords for other equipment with this unit.
Do not:
≥mix old and new batteries.
≥use different types at the same time.
≥heat or expose to flame.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ page 12), avoiding
obstacles, at a maximum range of 7 m directly in front of the unit.
STEP5 Radio and AC mains lead connections
Adhesive tape
AC mains lead
Main unit
AM loop antenna
Stand the antenna up on its base.
Place the antenna where reception is best.
Keep loose antenna cable away from other wires
and cables.
Click!
AM loop antenna FM indoor antenna
FM indoor antenna
Affix this end of the antenna where
reception is best.
≥Connect the AC mains lead after all other connections are complete.
≥Using an outdoor antenna (optional) (➜ page 29).
Conserving power
The main unit consumes a small amount of power, even when it is turned off (approx. 0.5 W). To save power when the unit is not to be used for a
long time, unplug it from the household mains socket.
You will need to reset some memory items after plugging in the unit.
AC mains lead
Re-tighten the
terminal screw.
Loosen the terminal
screw with a Phillips-
head screwdriver.
White
Red
Black
While pushing, insert the wire fully.
To household mains socket
STEP6 Preparing the remote control
R6/LR6, AA
1
3
2
Remote control Batteries
Insert so the poles (i and j) match those in the remote control.
≥Do not use rechargeable type
batteries.
Radio and AC mains lead connections / Preparing the remote control
HT855En.book Page 10 Tuesday, March 7, 2006 2:33 PM