Filter
Top Products
44
RQT7708
The radio
Press [TUNER] to put the remote control in TUNER mode.
Up to 15 stations can each be set in the FM and AM bands.
1 Press [FM/AM] to select “FM”.
2 Press [6] or [5] to tune to the
lowest frequency (“FM 87.9” MHz or
“FM 87.5” MHz).
3 Press and hold [ENTER].
Release the button when “AUTO” is displayed.
The tuner presets all the stations it can receive into the
channels in ascending order.
≥“SET OK” is displayed when the stations are set. The last
station to be set is then played.
4 Repeat steps 1 to 3 to set the AM
bands (the lowest frequency is
“AM 520” kHz).
1 Press [FM/AM] to select “FM” or
“AM”.
2 Press [6] or [5] to select the
frequency.
Press and hold [6] or [5] until the frequency starts
scrolling to start automatic tuning. Tuning stops when a station
is found.
1 Tune to the station (➜ above).
2 Press [ENTER].
3 While “PGM” is flashing on the display
Press the numbered buttons to select
a channel.
Alternatively, press [W CH] or [X CH] then press [ENTER].
The station occupying a channel is erased if another station is preset
to that channel.
1 Press [FM/AM] to select “FM” or “AM”.
2 Press the numbered buttons to select
the channel.
Alternatively, press [W CH] or [X CH].
To select a 2-digit number
e.g. 12: [S10] ➜ [1] ➜ [2].
When a stereo FM broadcast is being received.
∫ If noise is excessive in FM
Press [PLAY MODE] to display “MONO”.
Press [PLAY MODE] again to cancel the
mode.
The mode is also canceled when you
change the frequency.
∫ FM frequency step
Main unit only
The step is factory-set to 0.2 MHz, but you can change it to receive
broadcasts allocated in 0.1-MHz steps.
1 Press [INPUT SELECTOR]
on the main unit to select “FM”.
2 Press and hold [INPUT SELECTOR].
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
[Note]
Any FM/AM frequencies preset in channels will be changed by this
procedure. Preset them again.