Filter
Top Products
11
RQT7708
Other speaker setup options (Center speaker only)
∫ Attaching to a wall
[Note]
≥The wall or pillar on which the speakers are to be attached should be capable of supporting 10 kg (22 Ib.) per screw.
Consult a qualified building contractor when attaching the speakers to wall. Improper attachment may result in damage to the wall and
speakers.
≥Do not attempt to attach these speakers to walls using methods other than those described in this manual.
1 Drive a screw (not included) into a wall.
2 Fit the speaker securely onto the screws with the holes.
∫ Fitting speaker stands (not included)
Ensure the stands meet these conditions before purchasing them.
Observe the diameter and length of the screws and the distance between screws as shown in the diagram.
≥The stands must be able to support over 10 kg (22 lb.).
≥The stands must be stable even if the speakers are in a high position.
30–35 mm (1
3
/16q–1
3
/8q)
Wall or
pillar
‰7.5–9.4 mm (
19
/64q–
3
/8q)
8–11 mm (
3
/8q–
7
/16q)
117.5 mm
(4
11
/16q)
So that the speaker fits up against the wall squarely, be sure to
press the speaker cable down into the groove.
In this position, the speaker will likely fall
if moved to the left or right.
Move the speaker so the screw is
in this position.
5 mm (
13
/64q),
pitch 0.8 mm (
1
/32q)
60 mm (2
23
/64q)
Plate thickness plus 7 to 10 mm
(plus
9
/32q to
25
/64q)
Speaker stand
(not included)
Attach the stands
with these holes.
7708en.book 11 ページ ２００４年２月１４日 土曜日 午後３時２４分