Filter
Top Products
26
9 Mount the unit securely onto the screws.
A Move this unit so that the screw is in this position.
≥ Be sure that both the wall mount brackets are securely attached to the screws.
≥ If this unit is tilting forward, remove this unit from the screws and adjust by tightening the screws.
10 Push the lock pins fully into place.
A Rear of this unit
B Lock pin (supplied)
C Screw (not supplied)
≥ Be sure to attach both lock pins correctly.
11 Attach the cord to a wall with a screw (not supplied).
≥ Keep the screws out of reach of children to prevent swallowing.
≥ Check the strength of the installation location. The position in the wall where the screw is to be
attached should be capable of supporting over 20 kg (44.1 lbs). If the strength at any of these
positions is lacking, provide sufficient reinforcement.
A Rear of this unit
B Fall prevention cord (not supplied)
C Screw eye (not supplied)
e.g.
SCHTB50_10PPC_RQTX1165-P.book Page 26 Monday, May 10, 2010 11:58 AM