Filter
Top Products
Chapter 1 Preparation — About your projector
ENGLISH - 27
About your projector
Remote control
1
3
2
4
5
7
6
8
9
10
11
12
19
13
14
15
16
17
18
20
21
Front Side Top
Bottom
1 Remote control indicator
Blinks if any button in the remote control is pressed.
2 Power standby <v> button
Sets the projector to the state where the projector is switched
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
3 Power on <b> button
Starts projection when the <MAIN POWER> switch on the
projector is set to <ON> when the power is switched off
(standby mode).
4 Input selection (<RGB1>, <RGB2>, <DVI‑D>, <VIDEO>,
<HDMI>, <SDI 1/2>) buttons
Switches the input signal to project. (x page 56)
5 <MENU> button/<ENTER> button/asqw buttons
Used to navigate through the menu screen. (x page 59)
6 <ON SCREEN> button
Switches the on-screen display function on (display) or off
(hide). (x page 55)
7 <TEST> button
Displays the test pattern. (x page 57)
8 Number (<0> ‑ <9>) buttons
Used for entering an ID number or a password in a multiple
projector environment.
9 <STATUS> button
Displays the projector information.
10 <LIGHT> button
Pressing this button lights up the remote control buttons. The
lights will go off when the remote control operation goes idle for
10 seconds.
11 <AUTO SETUP> button
Automatically adjusts the image display position while projecting
the image.
[PROGRESS] is displayed on the screen while adjusting
automatically. (x page 56)
12 <SHUTTER> button
Used to temporarily turn off the image. (x page 55)
13 <ASPECT> button
Switches the aspect ratio of the image. (x page 57)
14 Lens (<FOCUS>, <ZOOM>, <SHIFT>) buttons
Adjusts the projection lens. (x page 51)
15 <FUNC> button
Assigns a frequently used operation as a shortcut button.
(x page 57)
16 <DEFAULT> button
Resets the content of the sub-menu to the factory default.
(x page 60)
17 <ID SET> button
Sets the ID number of the remote control in a multiple projector
environment. (x page 32)
18 <ID ALL> button
Used to simultaneously control all the projectors with a
single remote control in a multiple projector environment.
(x page 32)
19 <LOCK> button
Used to prevent unintended operation by careless pressing of
the buttons and prevent draining the remote control batteries.
20 Remote control signal transmitter
21 Remote control wired terminal
This is the terminal used to connect to the projector via a cable
when used as a wired remote control. (x page 33)
Attention
f Do not drop the remote control.
f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.
f Observe the following instructions that are indicated on the caution label at the back of the remote control:
g Do not use old battery with new one.
g Do not use batteries other than the type specied.