28
Using the Remote Control
2. While holding down
PRESET
, press the button for the the device you
want to set. The PRESET RECALL indicator lights.
The labels on the
CONTROL MODE
buttons are for your convenience
only. You can program any device to any button. For example, if
you do not have a DVD player but you wish to program your sec-
ond VCR, use
DVD
to enter the code for second VCR.
3. Point the remote control to the device desired and enter the three-
digit code. The remote control sends power on/off signal for the
device. If the code is correct, the device should turn on or off.
If the device does not function, repeat Steps 2 and 3 and try other
codes for the manufacturer. If it still does not function, you must
use the original remote control supplied with your device.
N
NN
No
oo
ot
tt
tes
eses
es:
::
:
• The remote control keeps the code you programmed for short peri-
ods of time, allowing you to replace the batteries without losing
the codes. However, if the remote control fails to operate after you
replace the batteries, re-enter the codes.
• You can clear all the programmed codes if necessary. Press
PRESET
,
DISC
, and
POWER
(on the top row, not
RECEIVER
POWER
at the bottom)
at the same time for about three seconds until the PRESET
RECALL indicator blinks three times.
CATV Brand Code
Jerrold 711,701,702,712,704,713,703,714,716,715
Pioneer 700
S.A. 705,706,708,709
Zenith 707,717,710
MD Brand Code
Denon 904
Kenwood 903
Pioneer 900
Sharp 902
Sony 901