Filter
Top Products
16
4. To select a memory position,
within about 5 seconds, repeat-
edly press REPEAT/SCAN until
the desired preset station number
appears (or press the desired pre-
set station number (1 to +10) on
the remote control), then press
PROGAM/MEMORY to store your
selection in memory.
Note: If MEMORY and the preset
station number disappear before
you press PROGAM/MEMORY,
begin again from Step 3.
5. Repeat Steps 1–4 to store up to
10 stations each in FM and AM.
Note: You cannot clear a station from
memory, but you can store a new one
in its place.
Caution: The CD-3322 will lose any
station(s) you stored in memory if pow-
er is disconnected or interrupted for
one minute or longer and the memory
backup batteries are run-down or not
installed (see “Using Batteries” on
Page 7).
Recalling a Stored Station
1. Press BAND to select AM or FM.
2. Repeatedly press REPEAT/SCAN
until the desired preset station
number appears (or press the
desired preset station number (1
to +10) on the remote control).
illustration
14-547.fm Page 16 Wednesday, June 30, 1999 4:23 PM