Filter
Top Products
4. With the supplied key's tabs facing inward, insert both of the keys
into the slots between the mounting sleeve and the stereo and press
the keys toward the back of the stereo. The sleeve begins to slide
off.
5. Remove the keys from the slots and slide the sleeve all the way off.
6. Put the sleeve into the opening in the dash, then secure it by bending
out all the tabs with a screwdriver.
7. Pull the wiring harness and the antenna cable through the sleeve and
dash, then reconnect the wiring harness and the antenna to the stereo.
8. Slide the stereo into the sleeve until it locks into place.
If you are securing the stereo in an existing mounting hole in the
dash, push the mounting bolt covered with the rubber mounting grommet
through the existing mounting hole and make sure it is secure.
Note: If the mounting bolt is too short to reach the mounting hole,
remove the rubber mounting grommet and screw the supplied
mounting bolt extender onto the mounting bolt. Then push the
rubber grommet onto the end of the bolt extender.
Otherwise, you can remove the rubber mounting grommet and use
the extender and the supplied nut and washer to attach the
supplied metal strap to the mounting bolt on the back of the
stereo.
If necessary, bend the metal strap to fit your vehicle's
mounting area. Then use the supplied sheet metal screw to
attach another section of the strap to a solid metal part of
the vehicle under the dashboard. This strap also helps ensure
proper electrical grounding of the stereo.
9. snap the plastic collar onto the front of the stereo.
10. Install your stereo's control panel (see "Replacing the control Panel"
in Faxback Doc. # 47544).
11. Reconnect the cable to the vehicle's negative (-) battery terminal.
Note: You will need to set the stereo's clock after you reconnect the
cable to the vehicle's battery (see "Setting the Clock" in
Faxback Doc. # 47544).