Filter
Top Products
MEMORY TUNING
You can manually store up to 12 AM and 18 FM stations in memory groups.
Each memory group (AM 1, AM 2, FM 1, FM 2, and FM 3) holds up to six
stations. You can also automatically store stations into a memory group.
To clear all the previously stored stations and the clock setting, use the
tip of a pen or a straightened paper clip to press RESET.
To store different stations, follow the instructions in "Manually Storing
Stations" or "Automatically Storing Stations", below. To set the clock,
see "Setting the Clock" above.
Manually Storing Stations
1. Repeatedly press BAND to select the desired memory group (AM 1 or AM 2
for AM, or FM 1, FM 2, or FM 3 for FM).
2. Tune to the station you want to store.
3. Hold down the desired memory location button until the frequency and
CH with the selected button number appear. The volume momentarily
mutes while the radio stores the station.
Automatically Storing Stations
1. Repeatedly press BAND to select the memory group where you want to
store stations. For example, to store the first group of AM stations
into AM 1, repeatedly press BAND until AM 1 appears.
2. Hold down AMS (automatic memory scan) for about 3 seconds. The stereo
scans the selected band and stores the first six stations it finds
(starting with the currently tuned frequency).
The frequency, memory group, and memory location number appear for
each station as it is stored. Then, after the stereo scans the band
once, it tunes to the last stored station and begins to play.
3. To stop the stereo from searching for stations before it automatically
stops, briefly press AMS.
Note: If a station has a weak signal or interference, the stereo
might not store it automatically. If this happens, you can
manually store the station.
Selecting a Stored Station