Filter
Top Products
High-Power In-Dash AM/FM Stereo Cassette
(120-2115) Operation Faxback Doc. # 47544
USING THE CONTROL PANEL
The stereo's control panel must be in place for the stereo to operate.
When you remove it, the stereo does not work. This is a simple but
effective security measure.
Any stored stations remain in memory when the control panel is removed.
REPLACING THE CONTROL PANEL
1. Insert the left end of the control panel into the left edge of the
recess. Slide the holes in the end of the control panel over the two
tabs in the recess.
2. Gently push the right edge of the control panel into the recess until
you hear a click.
REMOVING THE CONTROL PANEL
1. Press REL and the right end pops out slightly.
2. Slide the right end out first, then grasp the control panel and pull
it out to remove it.
3. Store the control panel in the supplied carrying case.
BASIC OPERATION
SETTING THE CLOCK
Note: You can set the clock only when the vehicle's ignition is turned on
or set to ACC.
1. Hold down F/C (Frequency/Clock) until the hour digit(s) blink(s), then
repeatedly press (+) or (-) until the correct hour appears.
2. Press F/C again. The minute digits blink. Repeatedly press (+) or (-)
until the correct minute appears.
3. Press F/C again to store the time.
ADJUSTING THE CONTROLS