Filter
Top Products
2. Turn on the external sound source.
3. Adjust the volume, bass, treble, balance, and fader settings to suit
your listening preference.
4. Press MODE again until CD disappears to listen to this stereo's radio
or tape player.
RADIO OPERATION
PLAYING THE RADIO
1. Press PWR to turn on the stereo.
2. Press BAND to select the AM or FM band. AM 1 or AM 2 appears when you
select an AM band. FM 1, FM 2, or FM 3 appears when you select an FM
band.
Notes: Each time you press BAND, the radio tunes to the last station
selected in the current band and memory group (see "Memory
tuning" below).
ST appears when an FM signal is received in stereo.
3. Tune to the desired station in one of the following ways.
Manual Tuning: Repeatedly press TUNE (/\) or TUNER (\/) to tune up or
down the selected band.
Seek Tuning: Hold down SEEK (\/) or SEEK (/\) for about 1 second to
tune to the next lower or higher station.
Note: If the stereo does not find a strong station when seeking, it
searches the band again for weaker stations. If no station is
found, press TUNE (\/) or TUNE (/\) to stop the seek function.
4. Press (+) or (-) to increase or decrease the volume as desired.
Notes: See "Adjusting the Controls" above for information about
changing the stereo's other settings.
To temporarily display the frequency of the station currently
playing, press F/C. The display shows the frequency for about
5 seconds, then returns to the clock display.