Filter
Top Products
19
Turning On the Receiver
You can change the input display name to “HDD”. When
the input display name has been changed “HDD” for
TAPE 1, the display name for the other button cannot be
changed to “HDD”.
After you changed the input display name, you can
operate the RI Dock using the remote controller supplied
with the receiver (see pages 10-11).
ON/STANDBY
STANDBY indicator
STANDBY/ON
Turning On and Standby
1
Press the [ON/STANDBY] button.
Alternatively, press the remote
controller’s [STANDBY/ON]
button.
The receiver comes on, the display
lights up, and the STANDBY indicator
goes off.
To turn the receiver off, press the
[ON/STANDBY] button, or press the
remote controller’s [STANDBY/ON]
button. The receiver will enter Standby
mode. To prevent any loud surprises
when you next turn on the receiver,
always turn down the volume before
you turn it off.
or
Receiver
Remote
controller
Changing the Input Display
1
Press the appropriate input
selector button.
The selected input name appears in the
display.
2
Press and hold down the input
selector button selected in the
Step 1 above for approximately 3
seconds to change the display
name.