Onkyo T-4555P Radio User Manual


 
22
Listening to XM Satellite Radio
—Continued
Once you have installed the XM Mini-Tuner and Home
Dock, you are ready to subscribe to XM Satellite Radio.
You’ll need a major credit card and your XM Radio ID.
There are three places you can find your 8-character
XM Radio ID:
1. On the XM Mini-Tuner
2. On the XM Mini-Tuner packaging
3. On XM Channel 0, as explained below
Notes:
RADIO ID cannot be selected in Category Search
mode. You must select Channel Search mode (see
page 23).
The following letters are not used in XM Satellite
Radio IDs: I, O, S, F.
XM Satellite Radio will transmit a special signal to
the T-4555P to activate the full channel lineup. Acti-
vation normally takes between 10 and 15 minutes, but
during busy peak periods, you may need to leave the
T-4555P turned on for up to an hour.
Setting the Satellite Radio Mode
1
Press the [SETUP] button.
2
Use the Up and Down Arrow
[ ]/[ ] buttons to select “SAT
Radio Mode,” and then press
[ENTER].
3
Use the Left and Right Arrow
[ ]/[ ] buttons to select “XM.”
The choices available depends on the
type of tuner board you’re using.
If you’ve not using satellite radio,
select None.
4
Press the [SETUP] button.
BAND
BAND
SETUP
///
ENTER
Remote controller
Remote controller
Remote controller
Remote controller
Selecting XM Satellite Radio
1
Press the [BAND] button repeat-
edly to select XM.
If “CHECK ANTENNA” appears on
the display, make sure the XM Mini-
Tuner is connected properly.
Signing Up for XM Satellite Radio
1
Use the Up and Down Arrow
[ ]/[ ] buttons to select “RADIO
ID.”
Alternatively, press the [DIRECT
TUNING] button, followed within 8
seconds by the [0] button and
[ENTER] button.
Your XM Satellite Radio ID number is
displayed. Write it below.
ID:
2
To sign up, go to:
http://activate.xmradio.com
Or call: 1-800-XM-RADIO
(1-800-967-2346)
For XM Canada, go to:
http://xmradio.ca
Or call: 1-877-GET-XMSR
(1-877-438-9677)
Remote controller
Remote controller
T-4555P_En.book Page 22 Wednesday, August 9, 2006 3:42 PM