Filter
Top Products
10
Getting to Know the T-4555P
—Continued
■
C-HDXM tuner board installed
■
C-AMFM tuner board installed
For detailed information, refer to the pages in parentheses.
A
XM ANTENNA (C-HDXM tuner board only)
(21)
This jack is for connecting the XM Mini-Tuner (not
supplied).
B
FM 75
Ω
ANTENNA (14)
This jack is for connecting an indoor or outdoor FM
antenna. An indoor FM antenna is supplied with
each tuner board.
C
AM ANTENNA (14)
These push terminals are for connecting an AM
loop antenna or outdoor AM antenna. An AM loop
antenna is supplied with each tuner board.
D
AUDIO OUTPUT (16)
Using the supplied audio cable, connect these out-
put jacks to an analog audio input on your amp.
E
REMOTE CONTROL (17)
These two identical (Remote Interactive) jacks
can be connected to the jacks on your other
Onkyo components for interactive control. To use
, the T-4555P must be connected with an
cable and an audio cable.
F
12V TRIGGER IN/OUT (17)
The 12V TRIGGER IN jack can be connected to the
12-volt trigger output on another component, so that
when the other component is turned on, the
T-4555P turns on as well.
The 12V TRIGGER OUT jack can be connected to
the 12-volt trigger input on another component, so
that when the T-4555P is turned on, the other com-
ponent turns on as well.
G
IR IN/OUT (18)
A commercially available IR receiver can be con-
nected to the IR IN jack, allowing you to control the
T-4555P while you’re in another room, or control it
when it’s out of sight, for example, installed in a
cabinet.
A commercially available IR emitter can be con-
nected to the IR OUT jack to pass IR (infrared)
remote control signals through to other components.
H
RS232
This port is for connecting the T-4555P to home
automation equipment and external controllers.
I
Power cord (6)
The power cord should be connected to a suitable
wall outlet.
Rear Panel
9
1234
5
67 8
9
4
5
67 82 3
See pages 16–18 for connection information.
T-4555P_En.book Page 10 Wednesday, August 9, 2006 3:42 PM