Filter
Top Products
18
Connecting the T-4555P
—Continued
You can use the following multi-room kits to control the
T-4555P when it’s out of range of the remote controller:
• Multiroom AV distribution and control systems such
as those made by Niles
®
and Xantech
®
.
Controlling the T-4555P When It’s Out of
Range
If the T-4555P is located in another room, installed in a
cabinet, or out of range of its remote controller, you can
use a commercially available IR receiver to pickup the
remote controller signals and feed them to the T-4555P,
as shown below.
Connect the IR receiver to the T-4555P as shown below.
Controlling Other Out-of-range
Components
If another component is out of range of its remote con-
troller, you can use a commercially available IR emitter
to retransmit the remote controller signals received at
the T-4555P’s IR IN, as shown below.
Connect the IR emitter to the T-4555P’s IR OUT, and
place the IR emitter in front of the other component’s
remote control sensor (usually located on its front
panel), as shown below. See the instructions supplied
with the IR emitter.
Only remote controller signals received by the
T-4555P’s IR IN are fed through to the IR OUT. Signals
picked up by the T-4555P’s remote control sensor are
not output.
Controlling Components That Are Out of Range
IR IN
T-4555P
Inside
cabinet
Remote controller
Connecting
block
IR receiver
: Signal flow
T-4555P
from connecting block
Miniplug cable
IR IN
IR OUT
Connecting
block
IR receiver
T-4555P
IR emitter
Remote controller
Other
component
: Signal flow
T-4555P
Remote control
Other component
sensor
from connecting block
Miniplug cable
Miniplug
IR emitter
IR Emitter
:Signal flow
T-4555P_En.book Page 18 Wednesday, August 9, 2006 3:42 PM