9
Remote Controller
—Continued
The T-433 doesn’t have its own remote controller, but it
can be controlled by using the RC-613S remote control-
ler that’s supplied with the Onkyo A-933 Integrated
Amplifier. The T-433 and A-933 must be connected
with an cable and an audio cable for this to work.
When controlling the T-433 with the A-933’s remote
controller, point the controller at the A-933’s remote
control sensor, as shown.
Notes:
• The remote controller may not work reliably if the
A-933 is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in
mind when installing.
• If another remote controller of the same type is used
in the same room, or the A-933 is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don’t put anything, such as a book, on the remote
controller, because the buttons may be pressed inad-
vertently, thereby draining the batteries.
• The remote controller may not work reliably if the
A-933 is installed in a rack behind colored glass
doors. Keep this in mind when installing.
• The remote controller will not work if there’s an
obstacle between it and the A-933’s remote control
sensor.
Using the Remote Controller
30°
5m
30°
RC-613S
A-933
Remote control
sensor
*En_T433_02.fm Page 9 Tuesday, February 15, 2005 3:09 PM