Filter
Top Products
16
Listening to the Radio
You can store up to 30 of your favorite radio stations as
presets for quick selection. Stations can be preset auto-
matically using the Auto Preset function or manually.
Notes:
•You can preset up to 30 FM/AM stations. If you try to
store more than this, the message “FULL” will appear
on the display.
• Using the remote controller while listening to an AM
radio station may cause interference.
• If the power cord is disconnected, or the power is off
for more than 2 weeks, the preset settings may be
lost, in which case, you’ll need to store them again.
With the Auto Preset function, you can search and store
all of the radio stations available in your area in one go.
Notes:
• All existing presets will be replaced when the Auto
Preset function is used.
• Be sure that your antennas are positioned so as to
obtain the best possible reception (see page 12).
Note:
Depending on your location, a preset may be stored
with no station and you’ll hear only noise when you
select it. In this case, delete the preset (see page 19).
Here you can tune into stations individually and store
them as presets. This allows you to store stations in any
order you like.
Notes:
•You can store up to 30 stations, and this can be any
combination of FM and AM stations. For example, 17
FM stations and 13 AM stations, or 8 FM stations and
22 AM stations.
• Although the numbering schemes for FM and AM
presets both start at 1, it doesn’t matter because FM
and AM presets are selected independently.
• Stations can be stored to presets in any order. For
example, you could store some AM stations to presets
2, 1, 9, and so on.
Presetting All Stations Automatically
(Auto Preset)
Press and hold the [MEMORY]
button for about 5 seconds until
auto tuning starts.
When the [MEMORY] button is
pressed, first, the MEM indicator lights
up. Next, “AUTO PRESET” flashes on
the display, followed by the tuning fre-
quency, and then auto tuning starts.
When a station is found, auto tuning
stops and the indicator lights up.
Starting at the bottom of the frequency
band, the T-433 automatically tunes
and stores up to 20 FM stations, then
up to 10 AM stations.
STANDBY/ON
STANDBY
DISPLAY
ACCUCLOCK TUNING PRESET
KEY MODE TIMER
BAND TUNING
/
PRESET
FM MODE
CLEAR
MEMORY
MEMORY
MEMORY
AUTO
MEM
Presetting Stations Manually
1
Use the [BAND] button to select
FM or AM.
The band switches between FM and
AM each time you press the button.
2
Use the [KEY MODE] button to
select Tuning mode (TUNING
indicator on).
The mode switches between Tuning
and Preset each time you press the but-
ton.
3
Press a TUNING/PRESET
[ ]/[ ] button for 1 second until
auto tuning starts.
The frequency display changes during
auto tuning.
Auto tuning stops when a station is
found.
STANDBY/ON
STANDBY
DISPLAY
ACCUCLOCK TUNING PRESET
KEY MODE TIMER
BAND TUNING
/
PRESET
FM MODE
CLEAR
MEMORY
MEMORY
TUNING/PRESET
KEY MODE
BAND
TUNING indicator
BAND
TUNING PRESET
KEY MODE
TUNING
/
PRESET
*En_T433_02.fm Page 16 Tuesday, February 15, 2005 3:09 PM