15
First Time Setup (European models only)
—Continued
Setting Accuclock to a Specific Station
The Accuclock function normally uses the FM station
with the strongest signal to set the clock. If the clock
cannot be set properly using that station, you can spec-
ify which FM station the Accuclock function uses. This
must be an FM station that supports RDS CT (Clock
Time) information.
Before proceeding, turn on the T-433.
Notes:
• If the clock does not set correctly, specify another FM
station and try again, or set the clock manually (see
page 21).
• If you don’t want the clock to be updated automati-
cally each day, you can turn off the Accuclock func-
tion (see page 15).
Selecting 12- or 24-hour Clock Display
Before proceeding, turn on the T-433.
Switching the Clock Display On or Off
While on Standby
Press the T-433’s [DISPLAY] button.
When the clock display is turned off, the ACCUCLOCK
indicator goes off.
Displaying the Clock & Day of the Week
(remote controller only)
Press the remote controller’s [CLOCK CALL] button.
Press the [CLOCK CALL] button again to turn off the
clock and day of the week display. You can save energy
by leaving the clock display turned off while the T-433
is on Standby.
1
Press the [TIMER] button.
“CLOCK” appears on the display.
If the clock has already been set, a
timer option appears instead. In this
case, you’ll need to press the [TIMER]
button repeatedly until “CLOCK”
appears.
2
Press the [MEMORY] button.
“AUTO” appears on the display. If
“MANUAL” appears, use the TUN-
ING/PRESET [ ]/[ ] buttons to
select “AUTO.”
3
Press the [MEMORY] button.
The display appears as shown.
4
Use the TUNING/PRESET
[ ]/[ ] buttons to tune into the
FM station.
The RDS indicator appears when tuned
into an RDS station, as shown.
Hint:
If you press the [MEMORY] button,
the T-433 will automatically search for
a suitable station.
STANDBY/ON
STANDBY
DISPLAY
ACCUCLOCK TUNING PRESET
KEY MODE TIMER
BAND TUNING
/
PRESET
FM MODE
CLEAR
MEMORY
MEMORY
TUNING/PRESET
TIMER
TIMER
MEMORY
MEMORY
TUNING
/
PRESET
5
Press the [MEMORY] button.
While the clock is being set, “WAIT”
flashes on the display. It may take a
few minutes to set the clock. When the
clock has been set, the message
“CLOCK ADJUSTED” scrolls across
the display, then the day and time are
displayed for a while.
1
Press the [TIMER] button repeat-
edly until “24H/12H” appears on
the display.
2
Press the [MEMORY] button.
3
Use the TUNING/PRESET
[ ]/[ ] buttons to select “24H”
or “12H.”
4
Press the [MEMORY] button.
The default setting is 24H.
MEMORY
DISPLAY
CLOCK
CALL
*En_T433_02.fm Page 15 Tuesday, February 15, 2005 3:09 PM