Filter
Top Products
61
First Time Setup—Continued
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
To use bi-amping or bridging, you must change the
“Speaker Type” setting. For hookup information, see
pages 27–30.
Notes:
• When bridging is used, the AV receiver is able to drive
up to 5.1 speakers in the main room.
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
Speaker Settings
The onscreen menus shown in this manual may be
slightly different from what you see on your TV.
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [ ]/[ ] but-
tons to select “2. Speaker
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.
INPUT SELECTOR
DISPLAY MUTING
G
U
I
D
E
E
X
I
T
PREV
CH
DIMMER
CDR/MD/DOCK
SAT
TAPE/AMP
SLEEP
MACRO
REMOTE MODE
--
/
---
10 11 12
TV VOL
PLAYLIST
RANDOM
D. TUN
CD
TUNER
TAPE
PHONO
REC
ENTER
T
O
P
M
E
N
U
M
E
N
U
VOL
CH
DISC
ALBUM
TV
VCR
CABLE
NET/USB
DVD
RECEIVER
CD
-
123
ZONE
3
ZONE
2
+
-
+10
0
CLEAR
456
789
S
E
T
U
P
R
E
T
U
R
N
NET/USB
2, 3
1
1, 7
2–
6
If you change these settings, you must run the auto-
matic speaker setup again (see page 64).
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
3
Use the Up and Down [ ]/[ ] but-
tons to select “1. Speaker Set-
tings”, and then press [ENTER].
The “Speaker Settings” menu appears.
4
Use the Up and Down [ ]/[ ] but-
tons to select “Speaker imped-
ance”, and use the Left and Right
[ ]/[ ] buttons to select:
4ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Use the Up and Down [ ]/[ ] but-
tons to select “Front(Speaker
A)”, and use the Left and Right
[ ]/[ ] buttons to select:
Normal:
Select this if you’ve connected your
front Speakers A normally.
Bi-Amp:
Select this if you’ve connected your
front Speakers A for bi-amped
operation.
BTL:
Select this if you’ve connected your
front Speakers A for bridged opera-
tion. The BTL indicator will appear
on the display.
Note:
“Bi-Amp” and “BTL” cannot be
selected if “Front(Speaker B)” is set to
“Bi-Amp” or “BTL”.
2–1. Speaker Settings
Speaker impedance
Speaker Type
Front(Speaker A)
Front(Speaker B)
6ohms
Normal
Not Use
MOVE VALUE RETURN
RETURN
EXIT
SETUP