Filter
Top Products
100
Advanced Setup—Continued
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Speaker Level Calibration
With the “Level Calibration” settings, you can adjust the
level of each speaker while listening to the test tone so
that the volume of each speaker is the same at the listen-
ing position. You can adjust the levels of front Speakers
A and front Speakers B independently. The other speak-
ers (i.e., subwoofer, center, surround, and surround back)
use the same level settings for Speakers A and Speakers
B.
Notes:
• The speakers cannot be calibrated while the output of
the AV receiver is muted.
• The test tone is output at the standard level for THX,
which is 0 dB (absolute volume setting 82). If you nor-
mally listen at volume settings below this, be careful
because the test tone will be much louder.
7
Use the Up and Down [ ]/[ ] but-
tons to select a speaker, and use
the Left and Right [ ]/[ ] but-
tons to specify the distance.
Specify the distance from the speaker
to your listening position.
Notes:
• You can specify different distances
for front Speakers A and front
Speakers B, but not the other speak-
ers (i.e., subwoofer, center, surround,
and surround back).
• The “Center” distance cannot be set
if the “Center” is set to “None”
(page 95) or “Not Use” (page 98).
• The “SurrRight” and “SurrLeft” dis-
tances cannot be set if the “Sur-
round” is set to “None” (page 95) or
“Not Use” (page 98).
• The “SurrBack R” and “SurrBack L”
distances cannot be set if “Speaker
Type: Front(Speaker A) or
Front(Speaker B)” is set to
“Bi-Amp” or “BTL” (page 61),
“SurrBack” is set to “None”
(page 95) or “Not Use” (page 98), or
“Powered Zone2” is being used
(page 132).
• The “Subwoofer” distance cannot be
set if “Subwoofer” is set to “No”
(page 96).
8
Repeat step 7 for each speaker.
9
Press the [SETUP] button.
Setup closes.
1
Press the [RECEIVER] REMOTE
MODE button, and then use the
remote controller’s [SP A] or
[SP B] button to select Speakers
A or Speakers B, respectively
(TX-NR906 only).
Notes:
• Speakers B cannot be selected if
“Speaker Type: Front(Speaker B)” is
set to “Not Use”.
• TX-SR876 continue with step 2 after
press the [RECEIVER] REMOTE
MODE button.
2
Press the [SETUP] button.
The main menu appears onscreen.
These settings are set automatically by the Automatic
Speaker Setup function (see page 64).
LISTENING MODE
DISPLAY MUTING
G
U
I
D
E
E
X
I
T
PREV
CH
DIMMER
CDR/MD/DOCK
SAT
TAPE/AMP
SLEEP
REMOTE MODE
SUBTITLE
AUDIO
REPEAT
PLAY MODE
PLAYLIST
RANDOMREC
ENTER
SURR
DIRECT
THX
PURE A
STEREO
ALL ST
T
O
P
M
E
N
U
M
E
N
U
VOL
CH
DISC
ALBUM
TV
VCR
CABLE
NET/USB
DVD
RECEIVER
CD
ZONE
2
+
-
S
E
T
U
P
R
E
T
U
R
N
SP A SP B
2, 7
1
1*
3-6
*TX-NR906 only