Filter
Top Products
74
Advanced Setup—Continued
DTS Setting
Neo:6 Music
Center Image 0 to 5 (default: 2)
The DTS Neo:6 Music listening mode creates 6-channel surround sound from 2-channel stereo sources. With
this setting, you can specify by how much the front left and right channel output is attenuated in order to create
the center channel.
When set to 0, the front left and right channel output is attenuated by half (–6 dB), giving the impression that
the sound is located centrally. This setting works well when the listening position is considerably off center.
When set to 5, the front left and right channels are not attenuated, maintaining the original stereo balance.
Audyssey Settings
After room correction and speaker setup is completed, Audyssey Dynamic EQ™ becomes “On” by default.
Dynamic EQ
Off: Audyssey Dynamic EQ off.
On: Audyssey Dynamic EQ on (default).
With Audyssey Dynamic EQ, you can enjoy great sound even when listening at low volume levels.
Audyssey Dynamic EQ solves the problem of deteriorating sound quality as volume is decreased by taking into
account human perception and room acoustics. It does so by selecting the correct frequency response and
surround volume levels moment-by-moment so that the content sounds the way it was created at any volume
level--not just at reference level.
Note:
In order to record with appropriate sound, Audyssey 2EQ™ is automatically deactivated during a recording.
After the recording is finished, Audyssey 2EQ™ and Audyssey Dynamic EQ™ will resume as previously set.
Dynamic Volume (see page 46)
Off: Audyssey Dynamic Volume™ off.
Light: Light Compression Mode becomes active.
Medium: Medium Compression Mode becomes active.
Heavy: Heavy Compression Mode becomes active. This setting affects volume the
most, causing all sounds to be of equal loudness.
Note:
“Dynamic Volume” becomes active when Dynamic EQ is set to “On”. Therefore, it is “Off” forcibly if
”Dynamic EQ” becomes “Off”.
Theater-Dimensional Setting
Listening Angle Wide: Select if the listening angle is 40 degrees (default).
Narrow: Select if the listening angle is 20 degrees.
With this setting, you can optimize the Theater-Dimen-
sional listening mode by specifying the angle of the front
left and right speakers relative to the listening position.
Ideally, the front left and right speakers should be equidis-
tant from the listening position and at an angle close to
one of the two available settings.
20°/40°
Front left speaker Front right speaker