Filter
Top Products
27
OFF
ON
STANDBY/ON
STANDBY
MASTER VOLUME
POWER
DISPLAY DVD VIDEO
1
VIDEO
2
VIDEO
3
VIDEO
4
VIDEO
5
TAPE
1
TAPE
2
AM
FM
PHONO
C D
OPEN/CLOSE
ZONE
2
()
GRN
REC
()
RED
AV
RECEIVER
TX-DS
989
OPEN/CLOSEREC
AUDIO MUTING
DISCTRACK
DVD
CD
PH
TUN
T2T1
V1
STEREO
123
654
7
+
10 0
ENT
89
SURROUND TH X DSP
LEVEL
+
CH SELRe-EQ
LEVEL
–
DIMMER
HOME THEATER CONTROLLER
RC-390M
LATE NIGHT
DIRECT DSP
V2 V3 V
–
SEND/LEARN
indicator
POWER ON
AUDIO MODE
STANDBY indicator
STANDBY/ON
POWER
POWER
STNBY
Connecting the power
Connecting the power
• The TX-DS989 is shipped with the main power
(POWER) switch in the on position (
ON
). When the
power cord is plugged in for the first time, the TX-
DS989 will automatically enter the standby state and
the STANDBY indicator will light (same condition
after step 2 below).
• Before you plug in the TX-DS989, confirm that all
connections have been made properly.
• Turning on the power may cause a momentary power surge,
which might interfere with other electrical equipment on the
same circuit, such as computers. If this happens, use a wall
outlet on a different circuit.
1. Plug the power cord into an AC wall outlet.
2. Press the POWER switch to set the TX-DS989
to standby state.
The STANDBY indicator will light up.
3. Press the STANDBY/ON button to turn on the
TX-DS989. The display will light up and the
STANDBY indicator will turn off.
Display
DVD
VIDEO
COMPONENT
ANALO
G
1
INPUT
If you press the STANDBY/ON button again, the receiver
returns to Standby mode.
Turning the power on from the remote controller:
Before you can use the remote controller, you must perform steps
1 and 2 above and place the TX-DS989 in the standby state.
1. Press the AUDIO MODE button.
2. Press the POWER ON button to turn on the TX-
DS989 (take it out of the standby state).
• To return the TX-DS989 to the standby state, press the
POWER STNBY button.