Filter
Top Products
28
Recording (continued)
6 Press the REC button.
The MD recorder is now in recording
standby mode.
REC
TRACK
DIGITAL IN
1
If “D. In Unlock” appears
The digital input source is not connected
properly. Check the connection for the
digital input source.
7 Adjust the recording level.
Refer to Step 7-1 and 7-2 on page 25.
To stop recording temporarily
Press the
button (or the button on the
remote control). To resume recording, press the
button again (or press the button on
the remote control).
To stop recording
Press the button.
To eject the MD
Press the
button and then the EJECT button.
Even with the Level Sync function turned off,
recording digital data from a CD to an MD
automatically numbers the tracks.
• For track numbers to be marked
automatically, the signature code included in
the digital signal at the beginning and end of
each track is necessary. Some equipment and
broadcasts do not include this signal, and in
such a case track numbers will not be marked
automatically.
In this case, the tracks are not numbered
automatically. Use the Level Sync function
described on the next page.
If the TOC indicator is lit steadily or flashing...
The track number and other information is
written in the MD’s TOC (Table of Contents) area
when the MD recorder ejects the disc, enters
stand-by mode, or stops recording.
Do not disconnect the power cable or move the
unit under the following circumstances. Otherwise,
the information will not be written correctly.
• The TOC indicator is lit.
The information to be written into the MD’s
TOC area is currently stored in the recorder’s
memory.
• The TOC indicator is flashing.
The recorder is now writing the information in
the MD’s TOC area.
TRACK
TOC
010 22040
R
4
L
DIGITAL IN
1
8 Press the button and then
start playing the recording
source immediately.
The TOC indicator appears as recording
starts.
The MD recorder stops recording
automatically when the remaining space
on the MD is insufficient to record the
next track.
MINIDISC
RECORDER
STANDBY
CD
INPUT
DUBBING
PUSH TO
ENTER
()
AMCS
DISPLAY EDIT
/
NO YES
REC
STANDBY
/
ON
MD
-
10 5
TX
REC MODE
REC
EDIT/NO
AMCS