Filter
Top Products
42
En
Level Calibration
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
■Left, Front High Left, Center
*1
, Front High Right,
Right, Surr Right, Surr Back Right, Surr Back
Left, Surr Left
`–12dB to 0dB
to +12dB in 1 dB step.
■Subwoofer
*1
`–15dB to 0dB to +12dB in 1 dB step.
Note
• Speakers that you set to “No” or “None” in the
“Speaker Configuration” cannot be selected (➔ 41).
• The speakers cannot be calibrated while the AV receiver is
muted.
*1
For the center speaker and subwoofer, the level settings made
by using the Audio menu are saved here as the default settings
(➔ 26).
Tip
• If you’re using a handheld sound level meter, adjust the level of
each speaker so that it reads 75 dB SPL at the listening position,
measured with C-weighting and slow reading.
Equalizer Settings
■Equalizer
`Audyssey:
This is selected automatically by Audyssey 2EQ
Room Correction and Speaker Setup function. The
Audyssey indicator will light (➔ 9) and
“Dynamic EQ” and “Dynamic Volume” become
available (➔ 44).
`Off
:
No Audyssey 2EQ equalizing will apply.
Note
• While the Direct listening mode is selected, this setting has no
effect.
• Audyssey equalizing does not work for DSD sources.
Main menu Audio Adjust
With the Audio Adjust functions and settings, you can
adjust the sound and listening modes as you like.
Multiplex/Mono
■Multiplex
This setting determines which channel of a stereo multi-
plex source is output. Use it to select audio channels or
languages with multiplex sources, multilingual TV
broadcasts, and so on.
Input Channel
`Main
:
The main channel is output.
`Sub:
The sub channel is output.
`Main/Sub:
Both the main and sub channels are output.
■Mono
This setting specifies the channel to be used for playing
any 2-channel digital source such as Dolby Digital, or
2-channel analog/PCM source in the Mono listening
mode.
Input Channel
`Left + Right
:
Both the left and right channels are output.
`Left:
Only the left channel is output.
`Right:
Only the right channel is output.
Dolby
■PLIIx Music (2ch Input)
These settings apply to only 2-channel stereo sources.
If you’re not using any surround back speakers, these
settings apply to Dolby Pro Logic II, not Dolby Pro
Logic IIx.
Panorama
`On:
Panorama function on.
`Off
:
Panorama function off.
With this setting, you can broaden the width of the front
stereo image when using the Dolby Pro Logic IIx Music
listening mode.
This setting is set automatically by Audyssey 2EQ
®
Room Correction and Speaker Setup function (➔ 28).
This setting is set automatically by Audyssey 2EQ
Room Correction and Speaker Setup function (➔ 28).
Audio Adjust