Filter
Top Products
14
En
Connections
Connecting the AV Receiver
■SKF-780
Before you connect the speakers, attach the supplied
speaker base to each SKF-780.
1. Turn the speaker upside down with the protection
cover attached.
2. Align the speaker base while the arrow mark is
headed in the same direction as the speaker’s face.
Be careful not to tip over the speaker.
3. Align the screw holes on the speaker base with those
on the bottom of each speaker, and affix the speaker
base using the supplied screws. Recommended torque
is 10 kgf·cm (9 lbf·in).
Be careful not to tip over the speaker.
4. Turn the speaker right side up.
5. Remove the protection cover.
SAFETY PRECAUTIONS:
• Attach the speaker bases in a manner that will not
allow the speakers to tip over.
• Be sure to tighten the screws when you attach the
speaker bases.
• Attach the speaker bases on a flat, level, and stable
floor.
• After you attach the speaker bases, make sure that
the speakers stand upright and are stable.
The speakers can easily be wall mounted by using the key-
hole slots.
Front, Surround and Surround Back
Speakers
To mount the front, surround and surround back speakers
vertically, use the keyhole slot shown to hang each speaker
on a screw that’s securely screwed into the wall.
■SKF-680, SKR-680, SKB-680
To prevent the speaker from vibrating against the wall,
attach two of the supplied rubber stoppers to the rear of
each speaker.
■SKR-780,SKB-780
Center Speaker
To mount the center speaker horizontally, use the two key-
hole slots shown to hang each speaker on two screws that
are securely screwed into the wall.
■SKC-680
To prevent the speaker from vibrating against the wall,
attach two of the supplied rubber stoppers to the rear of
each speaker.
Attaching the Speaker Bases
Top of SKF-780
Protection cover
Supplied screws
Speaker base
Bottom of SKF-780
Arrow mark
Wall Mounting
Rubber stoppers
Keyhole slot for
wall mounting
Keyhole slot for
wall mounting
Keyhole slot for wall mounting
Rubber
stoppers
8-1/4" (210 mm)