Filter
Top Products
60
En
Main menu Remote Controller Setup
Remote Mode Setup
See “Looking up for Remote Control Code”
(➔ page 67).
With this preference, you can protect your settings by
locking the setup menus.
Main menu Lock Setup
■ Setup
`Locked
`Unlocked
When “Locked” is selected, the setup menus will be
locked and you cannot change any setting.
You can change various audio settings from the Home
menu (➔ page 40).
Note
• These settings are not available in either of the following cases:
– a pair of headphones is connected.
–the “Audio TV Out” setting is set to “On” (➔ page 58).
–“HDMI Control(RIHD)” is set to “On” (➔ page 57) and
you’re listening through your TV speakers.
Tone Control Settings
■ Bass
`–10dB to 0dB
to +10dB in 2 dB steps.
You can boost or cut low-frequency sounds output
from the front speakers.
■ Treble
`–10dB to 0dB
to +10dB in 2 dB steps.
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio or THX listening
mode is selected.
Operating on the AV receiver
Note
• To bypass the bass and treble tone circuits, select the Direct,
Pure Audio or THX listening mode.
• This setting is not available when the multichannel Analog input
is selected.
Speaker Levels
■ Subwoofer Level
`–15.0dB to 0.0dB
to +12.0dB in 0.5 dB steps.
■ Center Level
`–12.0dB to 0.0dB to +12.0dB in 0.5 dB steps.
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to standby. To save the setting you made
here, go to “Level Calibration” (➔ page 48) before
setting the AV receiver to standby.
Note
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” or “None” in
“Speaker Configuration” (➔ page 46) cannot be adjusted.
Dolby Volume
■ Dolby Volume
See “Dolby Volume” of “Audio Adjust” (➔ page 50).
Note
• This setting cannot be used in either of the following cases:
– Pure Audio or Direct listening mode is selected.
– the multichannel analog input is selected.
– any of the THX listening modes is selected, with “Loudness
Plus” set to “On” or “Preserve THX Settings” set to “Yes”
(➔ page 49).
•When “Dolby Volume” is set to “On”, the “Dynamic EQ” and
“Dynamic Volume” settings of all input selectors are switched
to “Off”.
Remote Controller Setup
Lock Setup
Using the Audio Settings
1
Press RECEIVER followed by HOME.
2
Use / and ENTER to select “Audio”, and then
use / / / to make the desired selection.
1
Press TONE repeatedly to select either “Bass” or
“Treble”.
2
Use + and – to adjust.