Filter
Top Products
93
Controlling Other Components
—Continued
Remote Control Codes for Onkyo
Components Connected via
Onkyo components that are connected via are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via , use
the following remote control codes:
•[DVD] REMOTE MODE button
30627:
Onkyo DVD player without (default)
• [CD] REMOTE MODE button
71817:
Onkyo CD player without (default)
• [DOCK] REMOTE MODE button
6003:
Onkyo DS-A2 RI Dock without (default)
Note:
• If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TAPE
IN/OUT jacks, for to work properly, you must set
the Input Display accordingly (see page 48).
Resetting the REMOTE MODE Buttons
You can reset a REMOTE MODE button to its default
remote control code.
You can reset the remote controller to its default settings.
1
Make sure the Onkyo component is con-
nected with an cable and an analog
audio cable (RCA).
See page 40 for details.
2
Enter the appropriate remote control code
to the REMOTE MODE button.
•[DVD] REMOTE MODE button
31612:
Onkyo DVD player with
• [CD] REMOTE MODE button
71327:
Onkyo CD player with
•[TAPE] REMOTE MODE button
42157:
Onkyo cassette recorder with
(default)
• [DOCK] REMOTE MODE button
6004:
Onkyo DS-A1 RI Dock with
See the previous page for how to enter remote
control codes.
3
Press the REMOTE MODE button, point
the remote controller at the AV receiver,
and operate the component.
1
While holding down the REMOTE
MODE button that you want to
reset, press and hold down the
[AUDIO] button until the Remote
indicator lights up (about 3 sec-
onds).
2
Within 30 seconds, press the
REMOTE MODE button again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
Each of the REMOTE MODE buttons
is preprogrammed with a remote con-
trol code. When a button is reset, its
preprogrammed code is restored.
Resetting the Remote Controller
1
While holding down the
[RECEIVER] REMOTE MODE but-
ton, press and hold down the
[AUDIO] button until the Remote
indicator lights up (about 3 sec-
onds).
2
Within 30 seconds, press the
[RECEIVER] REMOTE MODE but-
ton again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
(3 seconds)
(3 seconds)