Filter
Top Products
48
First Time Setup
—Continued
Notes:
• When an HDMI IN is assigned to an input selector in
“HDMI Input Setup” on page 46, this input assign-
ment is automatically set to the same HDMI IN. And
in addition to the usual inputs (e.g., COAX1, COAX2,
etc.), you can also select HDMI inputs. If you change
the input assignment from an HDMI IN to one of the
other inputs (e.g., COAX1 or COAX2), be sure to set
the“Automatic Audio Input Selection Setup” on
page 49 to the same input (e.g., COAX1 (Auto) or
COAX2 (Auto)).
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TAPE IN/OUT
jacks, or connect an RI Dock to the CBL/SAT IN jacks,
for to work properly, you must change this setting.
This setting can only be changed on the AV receiver.
iPod with video: If you’re using an iPod that supports
video output with the DS-A1 RI Dock, connect the
DS-A1 to the CBL/SAT IN jacks.
Note:
• DOCK can be selected for the TAPE input selector or
CBL/SAT input selector, but not both at the same time.
2
Use the Up and Down [ ]/[ ]
buttons to select “1. Input
Assign,” and then press
[ENTER].
3
Use the Up and Down [ ]/[ ]
buttons to select “3. Digital
Audio Input,” and then press
[ENTER].
4
Use the Up and Down [ ]/[ ]
buttons to select an input selec-
tor, and then use the Left and
Right [ ]/[ ] buttons to select:
COAX1
: Select if the component is
connected to DIGITAL IN
COAXIAL 1.
COAX2
: Select if the component is
connected to DIGITAL IN
COAXIAL 2.
OPT1
: Select if the component is
connected to DIGITAL IN
OPTICAL 1.
OPT2
: Select if the component is
connected to DIGITAL IN
OPTICAL 2.
- - - - -:
Select if the component is
connected to an analog
input.
5
Press the [SETUP] button.
Setup closes.
Changing the Input Display
1
Press the [TAPE] or [CBL/SAT]
input selector button so that
“TAPE” or “CBL/SAT” appears on
the display.
2
Press and hold down the [TAPE]
or [CBL/SAT] input selector but-
ton (about 3 seconds) to change
the setting.
Repeat this step to select MD, CDR, or
DOCK.
For the TAPE input selector, the setting
changes in this order:
For the CBL/SAT input selector, the
setting changes in this order:
CBL/SAT
↔
DOCK
ON/STANDBY
STANDBY
A SPEAKERS B
TONE
MOVIE/TV
LISTENING MODE
MUSIC GAME
DISPLAY MEMORY
CLEAR
DIGITAL INPUT TUNING MODE
PHONES
MULTI CH
THX
DVD VCR/DVR CBL/SAT AUX TAPE TUNER CD
SETUP
SETUP MIC
VIDEO
L AUDIO R
AUX INPUT
ENTER
RETURN
TUNING PRESET
MASTER VOLUME
AV RECEIVER
HT-R960
RT/PTY/TP
1, 2 1, 2
TAPE
CBL/SAT
or
TAPE
CBL/SAT
or
TAPE → MD → CDR
DOCK
→
→