Filter
Top Products
38
Listening to an FM/AM Station
—Continued
1
Turn on the power to the CD receiver.
2
Select FM or AM.
3
Press or repeatedly while observing
the display to tune in the desired frequency.
Each press of the button changes the frequency by
0.05 MHz for FM and 9 kHz for AM. Pressing and
holding down the button for more than one second
will change the frequency continuously.
While FM is selected, pressing and holding or
down a while, then releasing it, will automati-
cally raise (or lower) the frequency.
When using the remote controller, press INPUT /
to select FM or AM, and press / to tune
in the desired frequency.
If FM reception is not good
If reception is poor or much noise is heard, press YES/
MODE to turn off the AUTO indicator and switch to
monaural reception. In this way, you can reduce noise or
dropped signals. To return to AUTO tuning, press YES/
MODE again.
Using the Remote Controller
Selects an FM/AM station.
Selects a preset channel.
(Pressing selects a lower
channel number and pressing
selects a higher channel
number.)
Preset
channel
Press the number buttons as
described in the examples
below to select the desired
preset channel.
Press
8
10
22
represents the tens digit.
Enables you to manually
tune in a broadcast station.
(See the following section.)
Adjust the volume level.
(Pressing VOLUME increases
the volume level, and pressing
VOLUME decreases the
level.)
Manually Tuning a Broadcast Station
1
2
YES/MODE
AUTO
SOURCE
FM ST
SOURCE
Remote
controller
CD receiver