Filter
Top Products
50
Using the Timers—Continued
Notes:
•You must set the clock before you can program the
timers.
• Before programming a timer to turn on the radio, you
must preset the station you want to use. (See pages 41
and 42.)
• If you don’t operate any buttons for 60 seconds while
programming a timer, the procedure will be cancelled
and the previous display will reappear.
Programming the Timers
1
Press the [TIMER] button repeat-
edly to select timer 1, 2, 3, or 4, and
then press [ENTER].
If “Clock” appears, you need to set the
clock (see page 24, 47, 48).
2
Use the Previous and Next [ ]/
[] buttons to select Play or
Rec, and then press [ENTER].
If you can’t select Rec, make sure that
your Onkyo cassette deck or MD
recorder is properly connected to the
MD/TAPE jacks (pages 18 and 19) and
the Input Display is set accordingly
(page 27).
/
TIMER
STANDBY/ON
ENTER
Number buttons
or
3
Use the Previous and Next [ ]/
[] buttons to select the source,
and then press [ENTER].
You can select the following sources:
CR-715DAB
FM, TAPE, DOCK, LINE1, LINE2,
DIGITAL, CD, or DAB.
CR-715
FM, TAPE, DOCK, LINE1, LINE2, or
CD.
If you selected Rec, CD cannot be
selected as the source.
4
If you selected FM, or DAB, use the
Previous and Next [ ]/[ ] but-
tons to select the radio preset, and
then press [ENTER].
5
If you selected Rec, make sure the
name of the connected recorder is
flashing on the display, and then
press [ENTER].
You can select TAPE or MD.
6
Use the Previous and Next [ ]/
[] buttons to select Once or
Every, and then press [ENTER].
Select Once for on-off operation. Select
Every to perform the same operation
every week.